Show Pwa Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Port Web Authentication (PWA)
Table 25-1 show pwa Output Details
Output...
PWA Status
PWA IP Address
PWA Protocol
PWA Enhanced Mode
PWA Logo
PWA Guest Networking Status
PWA Guest Name
PWA Guest Password
PWA Redirect Time
Port
Mode
Auth Status
Quiet Period
MaxReq
25-14 Authentication Configuration
What it displays...
Whether or not port web authentication is enabled or disabled. Default
state of disabled can be changed using the set pwa command as
described in "set pwa" on page 25-15.
IP address of the end station from which PWA will prevent network
access until the user is authenticated. Set using the set pwa
ipaddress command as described in
page 25-19.
Whether PWA protocol is CHAP or PAP. Default setting of PAP can be
changed using the set pwa protocol command as described in
protocol" on page 25-19.
Whether PWA enhanced mode is enabled or disabled. Default state of
disabled can be changed using the set pwa enhancedmode
command as described in
Whether the Enterasys Networks logo will be displayed or hidden at
user login. Default state of enabled (displayed) can be changed using
the set pwa displaylogo command as described in
displaylogo" on page 25-18.
Whether PWA guest user status is disabled or enabled with RADIUS
or no authentication. Default state of disabled can be changed using
the set pwa gueststatus command as described in
gueststatus" on page 25-22.
Guest user name for PWA enhanced mode networking. Default value
of "guest" can be changed using the set pwa guestname command as
described in "set pwa guestname" on page 25-21.
Guest user's password. Default value of an empty string can be
changed using the set pwa guestpassword command as described in
"set pwa guestpassword" on page 25-22.
Time in seconds after login success before the user is redirected to the
PWA home page. Default of 5 can be reset using the set pwa
redirecttime command as described in
page 25-18.
PWA port designation.
PWA port control mode.
Whether or not the port state is disconnected, authenticating
authenticated, or held (authentication has failed).
Amount of time a port will be in the held state after a user
unsuccessfully attempts to log on to the network. Default value of 60
can be changed using the set pwa quietperiod command as
described in "set pwa quietperiod" on page 25-23.
Maximum number of log on attempts allowed before transitioning the
port to a held state. Default value of 2 can be changed using the set
pwa maxrequests command as described in
on page 25-24.
"set pwa ipaddress" on
"set pwa enhancedmode" on page 25-20.
"set pwa
"set pwa
"set pwa redirecttime" on
"set pwa
show pwa
"set pwa
maxrequests"