Set Spantree Tctrapsuppress; Clear Spantree Tctrapsuppress - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters

set spantree tctrapsuppress

Use this command to disable or enable topology change trap suppression on Rapid Spanning Tree
edge ports.
Syntax
set spantree tctrapsupress {disable | enable | edgedisable}
Parameters
disable | enable
edgedisable
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
By default, RSTP non‐edge (bridge) ports that transition to forwarding or blocking cause the
switch to issue a topology change trap. When topology change trap suppression is enabled, which
is the device default, edge ports (such as end station PCs) are prevented from sending topology
change traps. This is because there is usually no need for network management to monitor edge
port STP transition states, such as when PCs are powered on. When topology change trap
suppression is disabled, all ports, including edge and bridge ports, will transmit topology change
traps.
Example
This example shows how to allow Rapid Spanning Tree edge ports to transmit topology change
traps:
Matrix(rw)->set spantree tctrapsuppress disable

clear spantree tctrapsuppress

Use this command to clear topology change trap suppression settings.
Syntax
clear spantree tctrapsuppress
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
6-32 Spanning Tree Configuration
Disables or enables topology change trap suppression.
Disables sending topology change traps on edge ports.
set spantree tctrapsuppress