enable
When preempt mode is enabled this specifies a delay (in seconds) that a higher priority backup
router must wait to preempt a lower priority master. For more information on setting preempt
status, refer back to "preempt" on page 21‐67. For more information on setting VRRP priority,
refer back to "priority" on page 21‐64.
The "no" form of this command clears the preempt delay timer.
Example
This example shows how to set the preempt delay to 60 seconds on VLAN 1, VRID 1:
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#preempt-delay vlan 1 1 60
enable
Use this command to enable VRRP on an interface.
Syntax
enable vlan vlan-id vrid
no enable vlan vlan-id vrid
Parameters
vlan vlan‐id
vrid
Defaults
None.
Mode
Router command, Router configuration: Matrix>Router(config‐router)#
Usage
Before enabling VRRP, you must set the other options described in this section. Once enabled, you
cannot make any configuration changes to VRRP without first disabling it using the no enable
vlan command.
The "no" form of this command disables VRRP on an interface.
Example
This example shows how to enable VRRP on VLAN 1, VRID 1:
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#enable vlan 1 1
Specifies the number of the VLAN on which to enable VRRP. This
VLAN must be configured for IP routing as described in "Reviewing
and Configuring Routing" on page 2‐101.
Specifies the Virtual Router ID (VRID) associated with the
values are from 1 to 255.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-69
Configuring VRRP
vlan
‐id. Valid