Ip Irdp Preference; Ip Irdp Address - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring IRDP

ip irdp preference

Use this command to set the IRDP preference value for an interface. This value is used by IRDP to
determine the interface's selection as a default gateway address.
Syntax
ip irdp preference preference
no irdp preference
Parameters
preference
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
The "no" form of this command resets the interface's IRDP preference value to the default of 0.
Example
This example shows how to set the IRDP preference value to 80000000 seconds on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip irdp preference 80000000

ip irdp address

Use this command to add additional IP addresses for IRDP to advertise.
Syntax
ip irdp address ip-address preference
no ip irdp preference ip-address
Parameters
ip‐address
preference
Defaults
None.
21-58 Routing Protocol Configuration
Specifies the value to indicate the interface's use as a default router
address. Valid values are ‐2147483648 to 2147483647. The value of
80000000 indicates that the address, even though it may be advertised,
is not to be used by neighboring hosts as a default router address.
Specifies an IP address to advertise.
Specifies the value to indicate the address' use as a default router
address. Valid values are ‐2147483648 to 2147483647. The value of
80000000 indicates that the address, even though it may be advertised,
is not to be used by neighboring hosts as a default router address.
ip irdp preference