Clear Spantree Mstcfgid; Show Spantree Bridgeprioritymode - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters
Parameters
cfgname name
rev level
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the MST configuration name to "mstconfig":
Matrix(rw)->set spantree mstconfigid cfgname mstconfig

clear spantree mstcfgid

Use this command to reset the MST revision level to a default value of 0, and the configuration
name to a default string representing the bridge MAC address.
Syntax
clear spantree mstcfgid
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the MST configuration identifier elements to default values:
Matrix(rw)->clear spantree mstcfgid

show spantree bridgeprioritymode

Use this command to display the Spanning Tree bridge priority mode setting.
Syntax
show spantree bridgeprioritymode
Parameters
None.
6-18 Spanning Tree Configuration
Specifies an MST configuration name.
Specifies an MST revision level. Valid values are 0 ‐ 65535.
clear spantree mstcfgid