Traceroute; Show Ip Route Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Managing Switch Network Addresses and Routes
Table 12-2 show ip route Output Details
Output...
Destination
Gateway
Mask
TOS
Flags
Refcnt
Use
Interface

traceroute

Use this command to display a hop‐by‐hop path through an IP network from the device to a
specific destination host.
Syntax
traceroute [-w waittime] [-f first-ttl] [-m max-ttl] [-p port] [-q nqueries] [-s
src-addr] [-r] [-d] [-t tos] [-F] [-g gateway] [-I] [-n] [-v] [-x] host [packetlen]
Parameters
‐w waittime
‐f first‐ttl]
‐m max‐ttl
‐p port
‐q nqueries
‐s src‐addr
‐r
12-6 Network Address and Route Management Configuration
What it displays...
IP address of the host entry.
MAC address of the destination.
IP mask of the destination.
Type of Service setting.
Route status. Possible values and their definitions include:
U - route is usable (that is, "up")
G - destination is a gateway
H - host specific routing entry
R - host or net unreachable
D - created dynamically (by redirect)
M - modified dynamically (by redirect)
d - message confirmed
C - generate new routes on use
X - external daemon resolves name
L - generated by ARP
S - manually added (static)
1 - protocol specific routing flag
2 - protocol specific routing flag
Number of hosts referencing this address.
Number of packets forwarded via this route.
Interface type.
(Optional) Specifies time in seconds to wait for a response to a probe.
(Optional) Specifies the time to live (TTL) of the first outgoing probe
packet.
(Optional) Specifies the maximum time to live (TTL) used in outgoing
probe packets.
(Optional) Specifies the base UDP port number used in probes.
(Optional) Specifies the number of probe inquiries.
(Optional?) Specifies the source IP address to use in outgoing probe
packets.
(Optional) Bypasses the normal host routing tables.
traceroute