Clear Spantree Legacypathcost; Show Spantree Tctrapsuppress - Enterasys Matrix DFE-Gold Series Configuration Manual

clear spantree legacypathcost

clear spantree legacypathcost
Use this command to set the Spanning Tree default value for legacy path cost to 802.1t values.
Syntax
clear spantree legacypathcost
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the default path cost values to 802.1t:
Matrix(rw)->clear spantree legacypathcost

show spantree tctrapsuppress

Use this command to display the status of topology change trap suppression on Rapid Spanning
Tree edge ports.
Syntax
show spantree tctrapsuppress
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the status of topology change trap suppression:
Matrix(rw)->show spantree tctrapsuppress
Topology change trap suppression is currently enabled.
Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-31