Set Lldp Port Location-Info; Set Lldp Port Tx-Tlv - Enterasys Matrix DFE-Gold Series Configuration Manual

Link Layer Discovery Protocol and LLDP-MED
Example
This example enables transmitting LLDP‐MED traps on ports ge.1.1 through ge.1.6.
Matrix(rw)->set lldp port med-trap enable ge.1.1-6

set lldp port location-info

Use this command to configure LLDP‐MED location information on a port or range of ports.
Currently, only Emergency Call Services (ECS) Emergency Location Identification Number (ELIN)
is supported.
Syntax
set lldp port location-info elin elin-string port-string
Parameters
elin
elin-string
port-string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
After you configure a location information value, you must also configure the port to send the
Location Information TLV with the set lldp port tx‐tlv command. This example configures the
ELIN identifier 5551234567 on ports ge.1.1 through ge.1.6 and then configures the ports to send
the Location Information TLV.
Matrix(rw)->set lldp port location-info 5551234567 ge.1.1-6
Matrix(rw)->set lldp port tx-tlv med-loc ge.1.1-6

set lldp port tx-tlv

Use this command to select the optional LLDP and LLDP‐MED TLVs to be transmitted in
LLDPDUs by the specified port or ports. Use the show lldp port local‐info command to display
the values of these TLVs for the port.
Syntax
set lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap] [mgmt-
addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr] [max-frame] [med-
cap] [med-pol] [med-loc] [med-poe]} port-string
3-30 Discovery Protocols Configuration
Specifies that the ECS ELIN data format is to be used.
Specifies the location identifier. Value can be from 10 to 25 numerical
characters.
Specifies the port or range of ports to be affected.
set lldp port location-info