Clear Spantree Backuproottrapenable; Show Spantree Newroottrapendable - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters
Example
This example shows how to enable the backup root trap function:
Matrix(rw)->set spantree backuproottrapenable enable

clear spantree backuproottrapenable

Use this command to resets the Spanning Tree backup root trap function to the default state of
disabled.
Syntax
clear spantree backuproottrapenable.
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the backup root trap function:
Matrix(rw)->clear spantree backuproottrapenable

show spantree newroottrapendable

Use this command to display the state of the Spanning Tree new root trap function.
Syntax
show spantree newroottrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the status of the new root trap function:
Matrix(rw)->show spantree newroottrapenable
New Root Trap is set to enable
6-44 Spanning Tree Configuration
clear spantree backuproottrapenable