Set Rmon Host Properties; Set Rmon Host Status - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RMON
Out Octets
Broadcast Pkts 0
Multicast Pkts 0

set rmon host properties

Use this command to configure an RMON host entry.
Syntax
set rmon host properties index port-string [owner]
Parameters
index
port‐string
owner
Defaults
If owner is not specified, monitor will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how to configure RMON host entry 1 on Fast Ethernet port 5 in module 1:
Matrix(rw)->set rmon host properties 1 fe.1.5

set rmon host status

Use this command to enable an RMON host entry.
Syntax
set rmon host status index enable
Parameters
index
enable
Defaults
None.
Mode
Switch command, Read‐Write.
11-28 Network Monitoring Configuration
136
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 5. Maximum value is 65535.
Configures RMON host monitoring on a specific port.
(Optional) Specifies the name of the entity that configured this entry.
Specifies an index number for this entry. Maximum number of entries is
5. Maximum value is 65535.
Enables this host entry.
set rmon host properties