Set Vlanauthorization - Enterasys Matrix DFE-Gold Series Configuration Manual

set vlanauthorization

Mode
Switch command, Read‐Only.
Example
This example shows how to display VLAN Authorization configuration information for ports
ge.1.1‐3:
Matrix(su)->show vlanauthorization ge.1.1-3
VLAN Authorization Global Status:
VLAN Authorization Table
Port
--------------------------------------------------------------
ge.1.1
ge.1.2
ge.1.3
set vlanauthorization
Use this command to set the VLAN Authorization attributes.
Syntax
set vlanauthorization enable | disable | port port-list {[enable | disable] none
| tagged | untagged | dynamic}
Parameters
enable | disable
port port‐list
enable | disable
none | tagged |
untagged | dynamic
Defaults
None.
Mode
Switch command, Read‐Write.
:
Status Admin Egress
enabled untagged
disabled untagged
enabled untagged
enable ‐ Enable VLAN Authorization.
disable - Disable VLAN Authorization.
(Optional) Set port(s) attributes for VLAN Authorization.
enable ‐ Enable port VLAN Authorization.
disable - Disable port VLAN Authorization.
none ‐ No egress change will be made.
tagged - Port added to egress.
untagged - Port added to untagged egress.
dynamic - Use information in authentication response.
enabled
Oper Egress VLAN ID
untagged 4094
untagged none
untagged unknown
Enterasys Matrix DFE-Gold Series Configuration Guide 25-61
Configuring RFC 3580