Crankshaft Inspection - Honda 2004 Odyssey Service Manual

Engine Block
Crankshaft and Piston Removal
(cont'd)
15. Remove the bearing cap bolts (A) and bearing cap
side bolts (B), then remove the bearing cap (C).
B
16. Lift the crankshaft (A) out of the cylinder block,
being careful not to damage the journals.
A
17. Reinstall the main caps and bearings on the
cylinder block in the proper order.
7-14 7-14
A
C

Crankshaft Inspection

Out-of-Round and Taper
1. Remove the crankshaft from the cylinder block (see
page 7-12).
2. Clean the crankshaft oil passages with pipe
cleaners or a suitable brush.
3. Check the keyway and threads.
4. Measure out-of-round at the middle of each rod
and main journal in two places. The difference
between measurements on each journal must not
be more than the service limit.
Journal Out-of-Round
Standard (New): 0.005 mm (0.0002 in.) max.
Service Limit:
B
5. Measure taper at the edges of each rod and main
journal. The difference between measurements on
each journal must not be more than the service
limit.
Journal Taper
Standard (New): 0.005 mm (0.0002 in.) max.
Service Limit:
0.010 mm (0.0004 in.)
0.010 mm (0.0004 in.)