Removing Overriding Profile Assignments From A Vc Range Or Vc Subrange - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide
atm bulk-config
auto-configure atm1483
profile atm1483 bulk-config-name
644

Removing Overriding Profile Assignments from a VC Range or VC Subrange

When you issue the no atm bulk-config command to remove an entire VC range (and
all VC subranges within that VC range), the router also removes any overriding profile
assignments configured for PVCs within those VC subranges. For example, the following
command removes the bulk-configured VC range named myBulkConfig and any overriding
profile assignments for PVCs within the VC subranges belonging to myBulkConfig.
host1(config-if)#no atm bulk-config myBulkConfig
When you issue the no atm bulk-config command to remove a particular VC subrange
in a bulk-configured VC range, the router also removes any overriding profile assignments
for PVCs within that VC subrange. However, overriding profile assignments for PVCs
within other VC subranges in the VC range remain intact. For example, the following
command removes one VC subrange (VPIs 0–4 and VCIs 21–1000) and only those
overriding profile assignments associated with this subrange.
host1(config-if)#no atm bulk-config myBulkConfig vc-range 0 4 21 1000
Use to create a bulk-configured VC range on a static ATM AAL5 interface for use by a
dynamic ATM 1483 subinterface.
For detailed information about how to use this command, see "atm bulk-config" on
page 637.
Example
host1(config)#atm bulk-config test1 vc-range 0 1 101 600
vc-range 3 5 201 3200
Use the no version to remove the specified VC range from the ATM AAL5 interface, to
remove the specified subranges from the specified VC range, or to remove all subranges
from the specified VC range. The no version also removes any overriding profile
assignments for ATM PVCs within the deleted VC range or VC subrange.
See atm bulk-config.
Use to configure the static ATM AAL5 interface to enable all bulk configurations and
support autodetection of the ATM 1483 dynamic encapsulation type.
You must issue this command to enable creation of a dynamic ATM 1483 subinterface.
Example
host1(config-if)#auto-configure atm1483
Use the no version to terminate autodetection of the ATM 1483 encapsulation type.
See auto-configure atm1483.
Copyright © 2010, Juniper Networks, Inc.