Configuring Subscriber Management for IP Subscribers on Dynamic Bridged Ethernet
Interfaces
You can use the JUNOSe subscriber management application to configure and manage
IP subscribers associated with a dynamic bridged Ethernet over static ATM 1483
interface column, as described in "Authenticating Subscribers on Dynamic Bridged
Ethernet over Static ATM Interfaces" on page 523.
To use the subscriber management application to configure IP subscribers on a
dynamic bridged Ethernet interface for RADIUS authentication:
1.
2.
3.
4.
Configuration Example Using subscriber Command
The following configuration example illustrates the preceding procedure. The example
has two parts:
host1(config-subif)#subscriber bridgedEthernet user-prefix charlie domain myisp
password-prefix lucy
Use the no version to remove the subscriber.
See subscriber.
Define an IP service profile that contains the subscriber's RADIUS authentication
parameters including the username, domain, and password.
Configure the interface profile from which the router creates a dynamic bridged
Ethernet interface column.
a. Include the desired characteristics for the upper-layer encapsulation types.
b. (Optional) Specify the name of the route map used to configure the IP
subscriber interface.
c.
Use the bridge1483 service-profile command to assign the specified IP
service profile to the interface profile. The IP service profile contains the
RADIUS authentication parameters for subscribers on the dynamic bridged
Ethernet interface.
Define the underlying static or dynamic ATM 1483 subinterface on which the
dynamic bridged Ethernet interface column is built.
a. Assign the specified interface profile to the ATM 1483 subinterface.
b. Enable autodetection (autoconfiguration) of the bridged Ethernet upper-layer
encapsulation type.
c.
Define the ATM PVC over which data is transmitted.
(Optional) Use the show profile command to verify assignment of the IP service
profile to the interface profile.
For information, see "show profile" on page 609.
The first part of the example shows how to use the subscriber command to
configure RADIUS authentication for IP subscribers on a dynamic bridged Ethernet
Chapter 17: Configuring Dynamic Interfaces
Configuring Bridged Ethernet Dynamic Interfaces
561