Optional Tasks On Atm 1483 Subinterfaces - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Optional Tasks on ATM 1483 Subinterfaces

atm aal5 shutdown
24
host1(config-if)#atm auto-configuration
Set the UNI version that the router uses when ILMI link autodetermination is
unsuccessful or ILMI is disabled.
host1(config-if)#atm uni-version 4.0
Configure the number of virtual circuits for each virtual path.
host1(config-if)#atm vc-per-vp 128
Configure a virtual path tunnel and its traffic parameters.
host1(config-if)#atm vp-tunnel 2 128
Enable scrambling of the ATM cell payload on a T3 or an E3 interface.
host1(config-if)#ds3-scramble
Set the time interval at which the router records bit and packet rates.
host1(config-if)#load-interval 90
Place the interface into loopback mode for router-to-router testing.
host1(config-if)#loopback diagnostic
Disable an interface.
host1(config-if)#shutdown
You can perform the following optional tasks on ATM 1483 subinterfaces:
Set the MTU.
host1(config-subif)#atm atm1483 mtu 7800
Configure SNMP link status traps.
host1(config-subif)#atm atm1483 snmp trap link-status
Set the administrative state of an ATM 1483 subinterface to disabled.
host1(config-subif)#atm atm1483 shutdown
Configure an advisory receive speed.
host1(config-subif)#atm atm1483 advisory-rx-speed 2000
Use to set an ATM AAL5 interface administrative state to disabled.
When you set the administrative state of the ATM AAL5 interface to disabled, the
router automatically disables all F5 OAM services configured on the associated VC,
and prevents the VC from receiving or transmitting F5 OAM cells.
Example
host1(config-if)#atm aal5 shutdown
Copyright © 2010, Juniper Networks, Inc.