Table of Contents
Advertisement
JUNOSe 11.0.x Physical Layer Configuration Guide
mdl string
mdl transmit
Other Optional Tasks
The following configuration tasks are optional when you configure a T3 controller:
cablelength
12
Configuration Tasks
Use the no version to restore the default situation, in which the interface does
not operate in the carrier environment.
See mdl carrier.
Use to specify an MDL message.
Example
host1(config-controll)#mdl string port 0800
Use the no version to restore the default value to the specified MDL message or
to all MDL messages.
See mdl string.
Use to enable transmission of MDL messages.
Specify the keyword path-id to transmit path identifications every second.
Specify the keyword idle-signal to send idle signals every second.
Specify the keyword test-signal to transmit test signals every second.
Example
host1(config-controll)#mdl transmit test-signal
Use the no version to disable transmission of the specified MDL message or all
MDL messages.
See mdl transmit.
Specify a cable length.
Change the clock source.
Change the framing format.
Enable or disable SNMP link status processing.
Assign a text description or an alias to the interface.
Use to adjust the transmit power appropriate to the length of the T3 cable.
Specify a cable length in the range 1–450 feet.
The router supports two transmit powers, one for a cable length 1–225 feet and
another for a cable length 226–450 feet. Therefore, it is not necessary for you
to know the exact length of your cable. You only need to know if the cable length
Advertisement
Table of Contents
