Chapter 19 Configuring Dhcp Local Server; Configuring The Dhcp Local Server; Basic Configuration Of Dhcp Local Server - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

Chapter 19
Configuring DHCP Local Server

Configuring the DHCP Local Server

Basic Configuration of DHCP Local Server

This chapter provides information for configuring the DHCP local server on the E
Series Broadband Services Routers. This chapter contains the following sections:
Configuring the DHCP Local Server on page 477
Configuring DHCP Local Address Pools on page 484
Configuring AAA Authentication for DHCP Local Server Standalone
Mode on page 487
Configuring the DHCPv6 Local Server on page 489
Deleting DHCPv6 Client Bindings on page 491
Configuring the Router to Work with the SRC Software on page 492
Tasks to configure the DHCP local server include:
Basic Configuration of DHCP Local Server on page 477
Limiting the Number of IP Addresses Supplied by DHCP Local Server on page 479
Excluding IP Addresses from Address Pools on page 479
Configuring DHCP Local Server to Support Creation of Dynamic Subscriber
Interfaces on page 480
Differentiating Between Clients with the Same Client ID or Hardware
Address on page 480
Logging Out DHCP Local Server Subscribers on page 481
Clearing an IP DHCP Local Server Binding on page 482
Using SNMP Traps to Monitor DHCP Local Server Events on page 482
Using DHCP Local Server Event Logs on page 483
Before you configure a DHCP local server, you must identify which mode to activate
(standalone mode or equal-access mode). Use equal-access mode, if you use the
Session and Resource Control (SRC) software for address allocation and managing
the subscribers. If you do not use SRC for managing subscribers, use standalone
mode. SRC contributes to the address pool selection and so when you use standalone
mode, SRC is not used for address allocation.
Configuring the DHCP Local Server
477