Hdlc Channels; References; Before You Configure An Interface - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual

References

Before You Configure an Interface

Copyright © 2010, Juniper Networks, Inc.

HDLC Channels

To identify an HDLC channel or the complete channelized T3 interface, use the format
slot/port:T1 channel/subchannel. Refer to the preceding sections for definitions of the
variables.
For more information about channelized T3 interfaces, consult the following resources:
RFC 1661—The Point-to-Point Protocol (PPP) (July 1994)
RFC 2495—Definitions of Managed Objects for the DS1, E1, DS2 and E2 Interface Types
(January 1999)
RFC 2495—Definitions of Managed Objects for the DS1, E1, DS2 and E2 Interface Types
(January 1999)
ANSI T1.107a-1990 Standard for Telecommunications—Digital Hierarchy – Supplement
to Formats Specification (August 1990)
ANSI T1.403-1989 Standard for Telecommunications—Network and Customer
Installation Interfaces – DS1 Metallic Interface – Robbed-bit Signaling State Definitions
(1989)
AT&T Technical Reference 54016—Requirements for Interfacing Digital Terminal
Equipment to Services Employing the Extended Superframe Format (September 1989)
For more information about bit error rate test (BERT) patterns, see:
ITU O.151—Error performance measuring equipment operating at the primary rate and
above (October 1992)
ITU O.153—Basic parameters for the measurement of error performance at bit rates
below the primary rate (October 1992)
T1M1.3 Working Group—A Technical Report on Test Patterns for DS1 Circuits (November
1993)
ANSI T1.404-1994 Standard for Telecommunications—Network-to-Customer – DS3
Metallic Interface Specification (1994)
Before you configure a channelized T3 interface, verify the following:
You have installed the line module and the I/O module correctly.
Each configured line module is able to transmit data to and receive data from your
switch connections.
For more information about installing line modules and I/O modules, see the ERX
Hardware Guide.
You should also have the following information available:
Chapter 1: Configuring Channelized T3 Interfaces
9