Table of Contents
Advertisement
Network and Security Manager Installation Guide
Validating Management System Status
Other Useful Commands
94
To start the HA Server process manually, enter the following command:
/usr/netscreen/HaSvr/bin/haSvr.sh start
The HA Server process automatically starts the GUI Server and Device Server processes.
NSM server processes always run with nsm user permissions, even if you have root user
permissions when you start them.
To validate the management system is started and running properly, we recommend
that you view the status of all the running server processes (the HA, Device, and GUI
Servers) to confirm that all services are running. For example:
/usr/netscreen/DevSvr/bin/devSvr.sh status
/usr/netscreen/GuiSvr/bin/guiSvr.sh status
/usr/netscreen/HaSvr/bin/haSvr.sh status
If any service is not running, stop all three processes and restart them using the HA Server
process.
If you are experiencing problems with the HA Server, run the following command for more
detailed information:
/usr/netscreen/HaSvr/utils/haStatus
The haStatus utility provides additional information describing the state and status of
the local/peer servers.
Table 16 on page 94 describes some useful commands which may assist in the installation
and troubleshooting of your high availability configuration:
Table 16: Useful Installation and Troubleshooting Commands
Command
less <filename>
netstat -n
while sleep 1;do netstat -n grep 192.168.0.;done
clear
Description
Displays the contents of a text file. The up
and down keys can be used to scroll. the letter
q
to quit.
Displays the current network connections
without resolving any addresses
Continually displays the command after the
word "do." This command is useful if you are
waiting for a server connection attempt of
data sync.
Clears the screen
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 and is the answer not in the manual?