Configuring Strm Log Management Components; Configuring An Event Collector - Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1 Administration Manual
Strm log management administration guide
Hide thumbs
Also See for SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1:
Table of Contents
Advertisement
76
U
D
SING THE
EPLOYMENT
Configuring STRM
Log Management
Components
Configuring an Event
Collector
Step 1
Step 2
Step 3
E
DITOR
This section provides information on configuring STRM Log Management
components and includes:
Configuring an Event Collector
•
Configuring an Event Processor
•
The Event Collector collects security events from various types of security devices
in your network.
To configure an Event Collector:
From either the Event View or System View, select the Event Collector you wish to
configure.
From the menu, select Actions > Configure.
Note: You can also use the right mouse button (right-click) to access the Action
menu items.
The Event Collector Configuration window appears.
Enter values for the parameters:
Table 5-4 Event Collector Parameters
Parameter
Event Collector Server
Listen Port
Destination Event
Processor
Listen Port
Event Targets
STRM Log Management Administration Guide
Description
The Event Collector monitors at least one device per
instance of the component.
Specify the destination Event Processor for
communications.
Specifies the listening port for event forwarding.
If the Event Collector includes an off-site target, this
parameter specifies the normalized event forwarding
device, separated by commas, using the following
format:
<device>:<type>
This parameter is for informational purposes only and is
not amendable.
Advertisement
Table of Contents
