Using Ethernet Show Commands - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

For e series broadband services routers - link layer configuration
Table of Contents

Advertisement

Using Ethernet show Commands

Use the show commands described in this section to display information about your
Ethernet configuration and to monitor Ethernet interfaces.
show interfaces fastEthernet
Output bps/pps Number of bits per second (bps) and packets per second
(pps) transmitted on this interface during the specified load interval
Time Time of day, in hh:mm:ss format, at which the router calculates the
bit rate and packet rate statistics for the current interval
Example 1 Displays bit rate and packet rate statistics over the default (5-second)
load interval for a single VLAN subinterface
host1#monitor vlan interface fastEthernet 0/0.1
Interface
----------------------- -------- --------------- ---------------
FastEthernet 0/0.1
FastEthernet 0/0.1
FastEthernet 0/0.1
FastEthernet 0/0.1
FastEthernet 0/0.1
FastEthernet 0/0.1
host1#^C
Example 2 Displays bit rate and packet rate statistics over a 10-second load
interval for two VLAN subinterfaces, with the time of day that the statistics were
calculated
host1#monitor vlan interface fastEthernet 0/0.1 fastEthernet 4/0.1
load-interval 10 display-time-of-day
Interface
----------------------- -------- --------------- --------------- --------
FastEthernet 0/0.1
FastEthernet 4/0.1
FastEthernet 0/0.1
FastEthernet 4/0.1
FastEthernet 0/0.1
FastEthernet 4/0.1
host1#^C
There is no no version.
See monitor vlan interface.
Use to display the status of Fast Ethernet interfaces, VLAN subinterfaces, or
S-VLAN subinterfaces.
You can specify the following keywords:
delta Specifies that baselined statistics are to be shown
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces
Seconds
between
polls
Input bps/pps
0
--/--
5
120240/100
5
120000/100
5
92400/77
5
88800/74
5
120000/100
Seconds
between
polls
Input bps/pps
0
--/--
0
--/--
10
120120/100
10
120000/100
10
120000/100
10
120000/100
Monitoring VLAN and S-VLAN Subinterfaces
Output bps/pps
--/--
120240/100
120000/100
92400/77
88800/74
120000/100
Time
Output bps/pps
(UTC)
--/-- 10:50:33
--/-- 10:50:33
120120/100 10:50:43
120000/100 10:50:43
120000/100 10:50:53
120000/100 10:50:53
191

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents