Table of Contents
Advertisement
JunosE 11.2.x Physical Layer Configuration Guide
Monitoring Ethernet Interfaces
Setting Statistics Baselines
baseline interface fastEthernet | gigabitEthernet | tenGigabitEthernet
Using Ethernet show Commands
show interfaces fastEthernet
196
host1(config-if)#shutdown
Use the no version to restart a disabled Ethernet interface.
See shutdown.
This section explains how to use the show commands to display the physical
characteristics and the configured settings for Ethernet interfaces.
NOTE: The E120 and E320 routers output for monitor and show commands is identical
to output from other E Series routers, except that the E120 and E320 router output also
includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
The router stores statistics in counters that reset only when you reboot. However, you
can establish a baseline for Ethernet statistics by setting a group of reference counters
to zero.
Use to establish a baseline for Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet
statistics on a line module or an SRP module.
Use the delta keyword with the show interfaces fastEthernet, the show interfaces
gigabitEthernet, or the show interfaces tenGigabitEthernet command to display
baselined statistics.
See baseline interface.
Use the show commands described in this section to display information about your
Ethernet configuration and to monitor Ethernet interfaces.
Use to display the status of Fast Ethernet interfaces.
You can specify the following keywords:
delta—Specifies that baselined statistics are to be shown
brief—Displays the operational status of all configured interfaces
Field descriptions
FastEthernet interfaceSpecifier—Status of the hardware on this interface
up—Hardware is operational
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
