Using Atm Show Commands - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

Using ATM show Commands

show atm aal5 interface
Copyright © 2010, Juniper Networks, Inc.
host1#monitor atm vp atm 12/0 0 atm 12/0 1 load-interval 15
display-time-of-day
Interface
----------------- ----- -------- --------------- --------------- --------
ATM 12/0
ATM 12/0
ATM 12/0
ATM 12/0
ATM 12/0
ATM 12/0
host1# ^C
There is no no version.
See monitor atm vc.
See monitor atm vp.
Use the show commands described in this section to display information about your
ATM configuration and monitor ATM interfaces.
You can use the output filtering feature of the show command to include or exclude lines
of output based on a text string you specify. See section show Commands in JunosE
System Basics Configuration Guide.
Use to display information about a configured ATM AAL5 interface.
Field descriptions
AAL5 Interface operational status—Operational status of the AAL5 interface: up,
down, lowerlayerDown
time since last status change—Time since last reported change to the AAL5 interface
operational status
SNMP trap link-status—Whether SNMP link status traps are enabled or disabled on
the ATM AAL5 interface
Auto configure ATM 1483 status—Setting of the autoconfiguration feature for a
dynamic ATM 1483 subinterface configured over the ATM AAL5 interface:
enabled—Autodetection of the ATM 1483 dynamic encapsulation type is enabled
on the ATM AAL5 interface
disabled—Autodetection of the ATM 1483 dynamic encapsulation type is not
currently enabled on the ATM AAL5 interface
InPackets—Number of packets received on this interface
InBytes—Number of bytes received on this interface
Seconds
between
VPI polls Input bps/pps
0 0 --/--
1 0 --/--
0 15 6634352/6478
1 15 6633608/6478
0 15 6635176/6479
1 15 6635040/6479
Chapter 1: Configuring ATM
Time
Output bps/pps (UTC)
--/-- 17:36:19
--/-- 17:36:19
6634352/6478 17:36:34
6633608/6478 17:36:34
6635176/6479 17:36:49
6635040/6479 17:36:49
71