Using Atm Show Commands - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide

Using ATM show Commands

Use the show commands described in this section to display information about your
ATM configuration and monitor ATM interfaces.
You can use the output filtering feature of the show command to include or exclude
lines of output based on a text string you specify. See section show Commands in
JUNOSe System Basics Configuration Guide.
show atm aal5 interface
74
Monitoring ATM
ATM 12/0
ATM 12/0
ATM 12/0
host1# ^C
Example 3 Displays bit rate and packet rate statistics over a 10-second load
interval for two ATM VPs
host1#monitor atm vp atm 12/0 0 atm 12/0 1 load-interval 10
Interface VPI
----------------- ----- -------- --------------- ---------------
ATM 12/0 0
ATM 12/0 1
ATM 12/0 0
ATM 12/0 1
ATM 12/0 0
ATM 12/0 1
host1#^C
Example 4 Displays bit rate and packet rate statistics over a 15-second load
interval for two ATM VPs, with the time of day that the statistics were calculated
host1#monitor atm vp atm 12/0 0 atm 12/0 1 load-interval 15
display-time-of-day
Interface VPI
----------------- ----- -------- --------------- --------------- --------
ATM 12/0 0
ATM 12/0 1
ATM 12/0 0
ATM 12/0 1
ATM 12/0 0
ATM 12/0 1
host1# ^C
There is no no version.
See monitor atm vc.
See monitor atm vp.
200 5 6633264/6477
100 5 6632856/6477
200 5 6633264/6477
Seconds
between
polls Input bps/pps
0 --/--
0 --/--
10 6635312/6479
10 6634288/6478
10 6637664/6482
10 6637872/6482
Seconds
between
polls Input bps/pps
0 --/--
0 --/--
15 6634352/6478
15 6633608/6478
15 6635176/6479
15 6635040/6479
6633472/6478 17:33:11
6632856/6477 17:33:16
6633056/6477 17:33:16
Output bps/pps
--/--
--/--
6635312/6479
6634288/6478
6637664/6482
6637872/6482
Time
Output bps/pps (UTC)
--/-- 17:36:19
--/-- 17:36:19
6634352/6478 17:36:34
6633608/6478 17:36:34
6635176/6479 17:36:49
6635040/6479 17:36:49