Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 3097

Table 392: show lldp Output Fields (continued)
Field Name Field Description
LLDP-MED TLVs supported on the switch:
Supported LLDP MED
TLVs
show lldp show lldp
show lldp detail
Copyright © 2010, Juniper Networks, Inc.
—TLV that advertises the primary function of the port.
LLDP MED capabilities
The capabilities values range from 0 through 15:
—Capabilities
0
—Network Policy
1
—Location Identification
2
—Extended Power via MDI-PSE
3
—Inventory
4
5–15 —Reserved
—TLV that advertises the port VLAN configuration and
Network policy
associated Layer 2 and Layer 3 attributes. Attributes include the policy
identifier, application types—such as voice or streaming video—802.1Q VLAN
tagging, and 802.1p priority bits and DiffServ code points.
—TLV that advertises the physical location of the endpoint.
Endpoint location
—TLV that advertises the power type, power source,
Extended power Via MDI
power priority, and power value of the port. It is the responsibility of the PSE
device (network connectivity device) to advertise the power priority on a port.
user@switch> show lldp
LLDP : Enabled
Advertisement interval : 30 seconds
Transmit delay : 2 seconds
Hold timer : 4 seconds
Notification interval : 0 Second(s)
Config Trap Interval : 0 seconds
Connection Hold timer : 300 seconds
LLDP MED : Disabled
MED fast start count : 3 Packets
Interface Parent Interface
all -
me0.0 -
user@switch> show lldp detail
LLDP : Enabled
Advertisement interval : 30 seconds
Transmit delay : 2 seconds
Hold timer : 4 seconds
Notification interval : 0 Second(s)
Config Trap Interval : 0 seconds
Connection Hold timer : 300 seconds
LLDP MED : Disabled
MED fast start count : 3 Packets
Interface Parent Interface
Chapter 92: Operational Commands for Access Control
LLDP LLDP-MED
Enabled -
Disabled -
LLDP LLDP-MED
Level of Output
detail
Neighbor count
2993