Warranty And Liability For Application Examples; Fundamental Safety Instructions For Safety Integrated - Siemens SIMATIC ET 200SP F-TM Equipment Manual

5.1.2

Warranty and liability for application examples

Application examples are non-binding and do not claim to be complete regarding
configuration and equipment as well as all eventualities. Application examples do not
represent customer-specific solutions. They are only intended to provide support for typical
tasks.
As user, you are responsible for ensuring that the products described are used correctly.
Application examples do not relieve you of the responsibility to use safe practices in
application, installation, operation and maintenance.
5.1.3

Fundamental safety instructions for Safety Integrated

Additional safety instructions and residual risks are provided outside of this section at the
relevant points of this system manual.
Risk minimization through Safety Integrated
Safety Integrated can be used to minimize the risk associated with machines and plants.
However, safe operation of the machine or system with Safety Integrated is only possible if
the machine manufacturer:
• Knows and complies with this technical user documentation, including the documented
• Carefully constructs and configures the machine/plant and verifies it through a carefully
• Implements and validates all the measures required in accordance with the
The use of Safety Integrated does not replace the machine/plant risk assessment carried
out by the machine manufacturer as required by the CE Machinery Directive.
In addition to using Safety Integrated functions, further risk reduction measures must be
implemented.
Danger to life as a result of undesirable motor movement when automatically restarting
An emergency stop must be performed according to Stop Category 0 (STO) (EN 60204-1).
The emergency stop must be ensured by external measures.
It is not permissible that the motor automatically restarts after an Emergency Stop, as this
represents danger to life as a result of the associated undesirable motor motion.
If individual safety functions are deactivated, an automatic restart is permitted under certain
circumstances depending on the risk analysis (except when Emergency Stop is reset). An
automatic start is possible when a protective door is closed, for example.
• Ensure that no automatic restart takes place in the indicated cases.
F-TM ServoDrive
Equipment Manual, 02/2020, A5E47579503-AA
DANGER
constraints, safety instructions and residual risks
implemented and documented acceptance test by qualified personnel
system/machine risk analysis by means of the programmed and configured Safety
Integrated functions or by other means
WARNING
Safety functions integrated in the drive
5.1 Basic safety information
33