Nortel DMS-100 Manual page 82

15 Monitor the CM reset terminal for the active CPU to determine if the switch
restarted.
Note: When the switch restarts, alphanumeric addresses appear in the
status bar for the reset terminal. When the switch restarts, A1 flashes in
the status bar.
If A1
flashes
does not flash after 5 min
At the MAP terminal
16
Determine if you must log in.
Note: The message Please Login indicates that you must log in.
Depending on your office parameters, the system can log you in
automatically.
Example of a MAP response:
Please Login.
If
you must log in
the system logged you in auto-
matically
17 Press the Break key
MAP response:
?
18 To log in to the MAP terminal, type
>LOGIN
and press the Enter key.
MAP response:
DMS-100 Family NA100 Recovery Procedures LET0015 and up
System level recovery procedures
Performing a reload-restart
Do
step 16
step 30
WARNING
Extended service interruption
The exact login procedure can vary, according to your office
configuration. If you need additional help, contact the next
level of support.
Do
step 17
step 21
2-35
(continued)