Nortel DMS-100 Manual page 140

Recovering from a dead system in a SuperNode SE switch
39
40
41
Seat and lock the cards, as follows:
a Use your fingers or thumbs to push on the upper and lower edges of the
faceplate. Make sure that the card sits completely in the shelf.
b Close the locking levers.
Determine if all the converters powered up correctly. All the Converter Off
lights go off to indicate the converters powered up.
If all the converters
powered up
did not power up
Power up the frame. Perform the procedure Clearing an Ext FSP DPCC
cabinet major alarm in Alarm and Performance Monitoring Procedures .
Complete the procedure and return to this point.
DMS-100 Family NA100 Recovery Procedures LET0015 and up
System level recovery procedures
Do
step 42
step 41
2-93
(continued)