Nortel DMS-100 Manual page 152

Recovering from a dead system in a SuperNode SE switch
106
107
108
109
110
111
To return the IOC or IOM to service, type
>RTS ioc_no
and press the Enter key.
where
ioc_no
is the number of the IOC or IOM
Repeat steps 104 through 106 for each IOC or IOM to recover. Continue this
procedure at step 108.
Log in to additional MAP terminals as required.
Note: Steps 54 through 58 describe how to log in to the MAP display.
Determine if your switch has Series III peripheral modules.
Note: Series III PMs have:
• CCS7 link interface units (LIU7s)
• High-speed link interface unit (HLIU)
• High-speed link router (HSLR)
• CCS7 server (SVR7)
• Ethernet interface units (EIUs)
• network interwork units (NIUs)
• voice processor units (VPUs)
• application processor units (APUs)
• frame relay interface units (FRIUs)
If your switch
has Series III PMs
does not have Series III PMs
Determine if a link peripheral processor (LPP) or enhanced link peripheral
processor (ELPP) contains any Series III PMs.
If an LPP or ELPP
contains any Series III PMs
does not contain any Series III
PMs
Determine if PDC power returned to the LPP(s).
If PDC power
returned to the LPP(s)
did not return to the LPP(s)
DMS-100 Family NA100 Recovery Procedures LET0015 and up
System level recovery procedures
Do
step 110
step 131
Do
step 111
step 126
Do
step 115
step 112
2-105
(continued)