Nortel DMS-100 Manual page 117

2-70 System level recovery procedures
Recovering from a dead system in a SuperNode switch
At the MAP terminal
86
87
88
89
90
91
297-8021-545 Standard 14.02 May 2001
b Press the RESET button on the power converter until the CONVERTER
FAIL LED goes off.
c Release the RESET button.
To access the NET level of the MAP display, type
>NET
and press the Enter key.
Example of a MAP display:
Net
Plane 01234 56789
0 0000
1 0000
JNET:
To manually busy the network module for a return to service, type
>BSY plane_no
and press the Enter key.
where
plane_no
is the network plane number (0 or 1)
pair_no
is the network plane pair number (0 to 31)
To return the network module to service, type
>RTS plane_no
and press the Enter key.
where
plane_no
is the network plane number (0 or 1)
pair_no
is the network plane pair number (0 to 31)
Repeat steps 78 through 88 for each JNET shelf.
When all JNET shelves are recovered, proceed to step 90.
Determine if there are additional IOCs and MAP terminals to recover.
If additional IOCs and MAP ter-
minals
require recovery
are recovered
Restore power to all power inverters in the office that remain.
11111 11111
01234 56789
pair_no
pair_no
Do
step 91
step 103
(continued)
22222 22222 33
01234 56789 01