Nortel DMS-100 Manual page 163

2-116 System level recovery procedures
Recovering from a dead system in a SuperNode SE switch
171
172
173
174
175
176
177
178
179
297-8021-545 Standard 14.02 May 2001
Perform the procedure Allocating recording volumes in the DIRP utility in
Routine Maintenance Procedures . Complete the procedure and return to this
point.
Consult the next level of support. Determine if you must recover other DIRP
subsystems at this point (for example, JF, OM).
If you
must recover other DIRP sub-
systems
do not need to recover other
DIRP subsystems
Perform the correct procedures in Alarm and Performance Monitoring
Procedures . Complete the procedures and return to this point.
To determine if the system generated DIRP logs, type
>LOGUTIL;OPEN DIRP
and press the Enter key.
If the system
generated DIRP logs
did not generate DIRP logs
Refer to the Log Report Reference Manual and perform the correct action.
Complete the log report activities and return to this point.
Determine if the attempt to synchronize the clocks in step 70 was successful.
If synchronization
was successful
was not successful
To access the MS Clock level of the MAP display, type
>MS;CLOCK
and press the Enter key.
To synchronize the clocks, type
>SYNC
and press the Enter key.
To access the CM level of the MAP display, type
>CM
and press the Enter key.
Do
step 173
step 176
Do
step 175
step 176
Do
step 179
step 177
(continued)