Nortel DMS-100 Manual page 449

5-98 Emergency power conservation recovery procedures
Emergency power conservation
Emergency shutdown of maintenance trunk modules
4
5
At the shelf
6
7
8
297-8021-545 Standard 14.02 May 2001
and press the Enter key.
To access the PM level of the MAP display, type
>PM;POST MTM pm_no
and press the Enter key.
where
pm_no
is the PM identification number (0 to 999)
SysB ManB
PM 0
MTM 0
MTM 0 InSv
To manually busy the MTM, type
>BSY
and press the Enter key.
WARNING
Static electricity damage
When you handle circuits cards, wear a wrist strap that
connects to a wrist-strap grounding point. A grounding point
is on the frame supervisory panel (FSP) or the modular
supervisory panel (MSP). The wrist strap protects the cards
against static electricity damage.
WARNING
PM shelf failure
Unseat the NT0X70 processor and memory circuit card
before you power down the PM shelf. A firmware error will
occur if you do not unseat the NT0X70 processor and
memory circuit card.
Unseat the NT0X70 processor card.
Set the handle of the PWR switch in a downward position on the NT2X09
power converter in slot 17.
Set the handle of the PWR switch in a downward position on the NT2X70
power converter in slot 20.
OffL CBsy
2 2 0
0 1 0
(continued)
ISTb InSv
7 21
0 6