Nortel DMS-100 Manual page 60

JAM DONE
36 Monitor the CM reset terminal for the active CPU to determine if the switch
booted.
Note: When the switch boots, the reset terminal displays the response
Booting, followed by different diagnostic messages. Alphanumeric
addresses appear in the status bar. When the switch boot finishes, A1
flashes in the status bar.
If A1
flashes
does not flash after 15 min
At the MAP terminal
37 Determine if you must log in.
Note: The message Please Login indicates that you must log in. Your
office parameters determine if the system can log you in automatically.
Example of a MAP response:
Please Login.
If
you must log in
the system logged you in auto-
matically
38 Press the Break key.
Example of a MAP response:
?
39 To log in to the MAP terminal, type
>LOGIN
and press the Enter key.
Example of a MAP response:
Enter User Name
40 To enter the user name, type
>user_name
and press the Enter key.
DMS-100 Family NA100 Recovery Procedures LET0015 and up
System level recovery procedures
Booting a DMS switch
Do
step 37
Repeat step 6, or contact your
next level of support.
Do
step 38
step 42
2-13
(continued)