Nortel DMS-100 Manual page 141

2-94 System level recovery procedures
Recovering from a dead system in a SuperNode SE switch
At the CM RESET terminal for the INACTIVE CPU
42
At the CM RESET terminal for the ACTIVE CPU
43
At the CM RESET terminal for the INACTIVE CPU
44
45
At the CM RESET terminal for the ACTIVE CPU
46
47
297-8021-545 Standard 14.02 May 2001
Go to step 36.
To release the jam on the inactive CPU, type
>\RELEASE JAM
and press the Enter key.
RTIF response:
JAM RELEASE DONE
Monitor the CM RESET terminal for the active CPU to determine if the switch
booted.
Note: When the switch boots, the RESET terminal displays the response
Booting, followed by different diagnostic messages. Alphanumeric
addresses appear in the status bar of the RESET terminal. When the
switch boots, A1 flashes in the status bar.
If A1
flashes
does not flash after 15 min
To jam the inactive CPU, type
>\JAM
and press the Enter key.
RTIF response:
Please confirm: (YES/NO)
To confirm the command, type
>YES
and press the Enter key.
RTIF response:
JAM DONE
To override the active CPU, type
>\OVERRIDE
and press the Enter key.
RTIF response:
TEMP. RESET/JAM ENABLE
To boot the active CPU, type
>\BOOT SLM slm_no
Do
step 50
step 44
(continued)