Nortel DMS-100 Manual page 337

4-130 Recovery procedures for individual devices and services
Recovering a stuck LIU7
Recovering a stuck LIU7
At the MAP terminal
1
2
3
4
5
6
297-8021-545 Standard 14.02 May 2001
(continued)
WARNING
Contact the next level of support
Do not attempt this procedure before you contact the next
level of support.
To access the PM level of the MAP display, type
>MAPCI;MTC;PM
and press the Enter key.
To post the system-busy LIU7 that is not accessible, type
>POST LIU7 SYSB
and press the Enter key.
If the LIU7 that appears
is SysB (NA)
is SysB
To display the next system busy LIU7, type
>NEXT
and press the Enter key.
Repeat step 3 until you find the system-busy LIU7 that is not accessible.
Determine the location of the LIU7.
If the LIU7
is in an SCC shelf in a SuperNode SE
is in an LPP
To access the MS CARD level of the MAP display, type
>MAPCI;MTC;MS:CARD 12
and press the Enter key.
Note 1: In the example, card 12 is the NT9X73 T-bus to F-bus interface
card.
Note 2: In the example, the state of the tap appears under the F-bus Tap:
header.
Example of a MAP response:
Do
step 9
step 3
Do
step 6
step 9