Nortel DMS-100 Manual page 385

5-36 Emergency power conservation recovery procedures
Emergency power conservation measures
Restoring the LGCs, LTCs, and DTCs to duplex operation
9
10
11
At the MAP terminal
12
13
14
297-8021-545 Standard 14.02 May 2001
c Release the RESET button.
Reseat the NT6X45 master processor card in slot 8.
Reseat the NT6X45 signaling processor card in slot 12.
Reseat the NT6X69 message protocol card or the NT6X43 message
interface card in slot 18.
To access the peripheral module (PM) level of the MAP display, type
>MAPCI;MTC;PM
and press the Enter key.
To post the XPM, type
>POST pm_type pm_no
and press the Enter key.
where
pm_type
is the PM type (LGC, DTC, or LTC)
pm_no
is the PM identification number (0 to 999)
Example of a MAP response:
DTC 0 ISTb Links_OOS: CSide
Unit0: Act
Unit1: Inact
To identify the network type and network links associated with the manual
busy XPM unit, type
>TRNSL C
and press the Enter key.
Example of a MAP response for JNET:
LINK 0: NET 0 1 0;CAP MS;Status:OK
LINK 1: NET 1 1 0;CAP MS;Status:MBsy
LINK 2: NET 0 1 4;CAP MS;Status:OK
LINK 3: NET 1 1 4;CAP MS;Status:MBsy
LINK 4: NET 0 1 8;CAP MS;Status:OK
...
LINK 31 NET 1 1 60;CAP MS;Status:MBsy
Note: Links 5 to 30 do not appear.
Example of a MAP response for ENET:
0 , PSide
InSv
ManB
(continued)
0