Nortel DMS-100 Manual page 203

3-36 Node level recovery procedures
Recovering SuperNode SE application specific units
Recovering SuperNode SE application specific units
At the MAP
1
2
3
4
5
6
7
8
297-8021-545 Standard 14.02 May 2001
Access the MS shelf level of the MAP display by typing
>MAPCI;MTC;MS;SHELF
and pressing the Enter key.
Access the TFI card level by typing
>CARD card_number
and pressing the Enter key.
where
card_number
is the card number of the NT9X73 T-bus to F-bus interfacecard.
Determine if the F-buses are in service.
If the state of the F-buses is
InSv
SysB
Manually busy each F-bus by typing
>BSY 0 FBUS; BSY
and pressing the Enter key.
Return each manual-busy F-bus to service by typing
>RTS 0 FBUS; RTS
and pressing the Enter key.
Determine if both F-buses have returned to service.
If both F-buses have
returned to service
not returned to service
Clear any MS alarms that may be preventing the F-buses from returning to
service. If necessary, consult your next level of support.
Once the F-buses are in service, continue this procedure at step 8.
Determine what type of ASUs are equipped on the SuperNode SE LIS or ENI
shelf you are recovering.
If the SuperNode SE LIS or ENI
shelf is equipped with
any NIUs
Do
step 8
step 4
1 FBUS
1 FBUS
Do
step 8
step 7
Do
step 9
(continued)