Nortel DMS-100 Manual page 58

At the CM reset terminal for the ACTIVE CPU
26 To override the active CPU, type
>\OVERRIDE
and press the Enter key.
RTIF response:
TEMP. RESET/JAM ENABLE
27 To jam the active CPU, type
>\JAM
and press the Enter key.
RTIF response:
Please confirm: (YES/NO)
Note: An active CPU jam causes a switch of activity. A jam causes the
active CPU to become inactive.
28 To confirm the command, type
>YES
and press the Enter key.
RTIF response:
JAM DONE
29 Monitor the CM reset terminal for the active CPU to determine if the switch
booted.
Note: When the switch boots, the reset terminal displays the response
Booting, followed by different diagnostic messages. Alphanumeric
addresses appear in the status bar. When the switch boot finishes, A1
flashes in the status bar.
If A1
flashes
does not flash after 15 min
At the CM reset terminal for the INACTIVE CPU
30 To boot the inactive CPU, type
>\BOOT SLMslm_no
and press the Enter key.
where
slm_no
is the number of the SLM (0 or 1) that contains the most recent
DMS-100 Family NA100 Recovery Procedures LET0015 and up
System level recovery procedures
Booting a DMS switch
Do
step 37
Repeat step 6, or contact your
next level of support.
2-11
(continued)