Nortel DMS-100 Manual page 483

5-132 Emergency power conservation recovery procedures
Emergency power conservation
Emergency shutdown of one LGC, LTC, and DTC unit
3
4
5
6
297-8021-545 Standard 14.02 May 2001
CAUTION
Loss of service
You will lose service if you power down the active unit of the
PM.
Determine if the XPM unit that you will power down is the active (Act) or
inactive (Inact) unit from the MAP display.
If the unit
is active
is inactive
To switch the activity of the units, type
>SWACT
and press the Enter key.
The system determines the type of SWACT that the system can perform. The
system can perform a warm or a cold SWACT. The system displays a
confirmation prompt for the selected SWACT.
Example of a MAP response:
LGC 2 A Warm SwAct will be performed after
data sync of active terminals
Please confirm ("YES", "Y", "NO" or "N"):
If MAP response
indicates a cold SwAct
indicates a warm SwAct
To cancel the activity switch, type
>NO
and press the Enter key.
You cannot switch activity on the XPM at this time. Proceed as follows:
If to
power down the inactive unit
(continued)
Do
step 4
step 8
Do
step 5
step 7
Do
step 8