Nortel DMS-100 Manual page 265

4-58 Recovery procedures for individual devices and services
Recovering AMA data with block numbers
18
19
20
297-8021-545 Standard 14.02 May 2001
To copy the parallel AMA file to the tape, type
>DIRPCOPY AMA file_name
and press the Enter key.
where
file_name
is the parallel file name
Tn
is the number of the tape drive
start_no
is the first sequence number that you will recover (you obtained the
sequence number in step 4)
block_length is the first sequence number subtracted from the
last
sequence number (you obtained both sequence numbers in step 4)
Example input:
>DIRPCOPY AMA DIRPPARALLEL_AMA
Note: The length of time the DIRPCOPY utility requires to copy the file
depends on the length of the parallel file. The length of required time also
depends on the number of blocks that the DIRPCOPY utility must copy.
If
If the DIRPCOPY command
was successful
was not successful
For additional help, contact the next level of support.
The procedure is complete.
(end)
Tn start_no block_length
T2 5400
Do
Do
step 20
step 19
100