Nortel DMS-100 Manual page 487

5-136 Emergency power conservation recovery procedures
Emergency power conservation
Emergency shutdown of one LGC, LTC, and DTC unit
24
At the shelf
25
26
27
28
29
30
31
297-8021-545 Standard 14.02 May 2001
plane_no
is the ENET plane number recorded in step 19
link_no
is the network link number recorded in step 19
Repeat steps 21 to 23 for each speech link recorded in step 18. Continue the
procedure.
WARNING
Static electricity damage
Wear a wrist strap that connects to a wrist-strap grounding
point on the frame supervisory panel (FSP) or the modular
supervisory panel (MSP) to handle circuit cards. The wrist
strap protects the cards against static electricity damage.
The next step depends on the configuration of your unit. Unseat the NT6X43
message interface card or the NT6X69 message protocol card from slot 18.
Unseat the NT6X45 signaling processor card from slot 12.
Unseat the NT6X45 master processor card from slot 8.
Unseat the NT6X46 signaling processor memory card from slot 11.
Pull down and set the handle of the power converter POWER switch to the
OFF position.
Repeat steps 2 to 29 for each LGC, DTC, and LTC.
Note: The power converter is in slot 20.
Return to the procedure Emergency power conservation—Shutdown in this
document. Proceed when the step-action procedure directs you to go.
(end)