Nortel DMS-100 Manual page 323

4-116 Recovery procedures for individual devices and services
Recovering a stuck HLIU or HSLR
Recovering a stuck HLIU or HSLR
At the MAP terminal
1
2
3
4
5
297-8021-545 Standard 14.02 May 2001
DANGER
Contact your next level of support
Do not attempt this procedure before contacting your next
level of support.
Access the PM level of the MAP display by typing
>MAPCI;MTC;PM
and pressing the Enter key.
Post the system-busy HLIU or HSLR by typing
>POST HLIU SYSB
and pressing the Enter key.
or
>POST HSLR SYSB
and pressing the Enter key.
If the state of the HLIU or HSLR
is
SysB (NA)
SysB
Display the next system-busy HLIU or HSLR by typing
>NEXT
and pressing the Enter key.
Repeat step 3 until you find the system-busy (NA) HLIU or HSLR.
Determine the LIM associated with the stuck HLIU or HSLR by typing
>QUERYPM
and pressing the Enter key.
QueryPM
PM type: HLIU PM NO.: 0
LIM: 0 Shelf: 1 Slot: 8
Default Load: HCA11AV
Running Load: HCA11AV
Potential service affecting conditions:
Msg Channel #1 NA
TAP #0 OOS/NA
(continued)
Do
step 5
step 3
Status: SysB
LIU FTA 4240 1000