Honda Accord 2008 Manual page 2402

07/11/02 09:43:03 61TA0000_220_0372
4. Reconnect the connector to the front passenger's power window switch, turn the ignition switch to ON (II), and
make these input tests at the connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, go to step 5.
Cavity Wire
37 BLK
25 GRN
5. Turn the ignition switch to LOCK (0), open and close the driver's door, then disconnect the 37P connector from the
front passenger's power window switch again.
6. With the connector still disconnected, make these input tests at the connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, replace the front passenger's power window switch, and go to step 7.
Cavity Wire
3
· BLU
4
PNK
4 PNK
·
5 RED
1 ORN
29 BLU
: With mirror defogger
7. With the front passenger's power window AUTO UP/AUTO DOWN function, reset the power window control unit
(see page 22-253).
Test condition
Under all conditions
Under all conditions
Test condition
LT Ignition switch ON (II),
connect No. 25 and No.
· 3 (or No. 4) terminals,
and No. 4 (or No. 3)
and No. 37 terminals
with jumper wires.
Ignition switch ON (II),
· connect No. 25 and No.
4 (or No. 5) terminals,
and No. 5 (or No. 4)
and No. 37 terminals
with jumper wires.
Connect No. 25 and No.
1 terminals with a
jumper wire
Under all conditions,
disconnect the power
window master switch
37P connector
Test: Desired result
Measure the voltage to ground:
There should be less than 0.5 V.
Measure the voltage to ground:
There should be battery voltage.
Test: Desired result
Check the right power mirror
operation:
The right power mirror should UP
(or DOWN).
Check the right power mirror
operation:
The right power mirror should
LEFT (or RIGHT).
Check the right power mirror
defogger operation:
The right power mirror defogger
should work (the inside lower
edge becomes warm).
Check for continuity between the
No. 29 terminal and the power
window master switch 37P
connector No. 27 terminal:
There should be continuity.
Possible cause if desired
result is not obtained
• Poor ground (G505)
• An open in the wire
• Blown No. 13 (20 A) fuse in
the passenger's under-dash
fuse/relay box
• Faulty driver's under-dash
fuse/relay box
• Faulty passenger's under-dash
fuse/relay box
• An open in the wire
Possible cause if desired
result is not obtained
• Faulty right power mirror
• Poor ground (G505)
• An open in the wire
• Faulty right power mirror
• Poor ground (G503)
• An open in the wire
• Faulty right power mirror
defogger
Poor ground (G503)
•
• An open in the wire
An open in the wire
22-369