Intermec ColorCoder V4 Service Manual page 122

3.3 Ink Supply System, cont'd.
3.3:B Pump Unit, cont'd.
Intermec ColorCoder V4 – Service Manual Ed. 1
Precautions in Assembling
Set up cleaning
After installing the pump unit, carry out the set up cleaning in the
following procedure.
1. Connect the power cord. Set the ink cartridges and paper, and
switch on in service mode (see Chapter 6:5 Service Mode).
2. Supply the ink to the BJ head in the mainte nance mode [SETUP
CLEANING].
3. Release the tube release lever, and remove the transportation
connectors (1-901809-00) from the tube stations.
4. Remove the connector packing (1-901808-00) from the tube
connectors, and connect the tube connectors to the tube stations.
5. Close the tube release lever. Attach the PHS cover.
6. Execute [Cleaning(B)].
7. Exit from the service mode, and enter in the normal mode (see
Chapter 6:5 Service Mode).
8. Execute [Cleaning(B)].
9. Execute [Cleaning(A)].
10. Check the image quality in the modes [NOZ ADJ. PATTERN]
and [NOZ CHK. PATTERN], and then adjust the position of
the nozzles (see Chapter 6:3 Test Print, Test Pattern).
Chapter 3 Mechanical System
121