Intermec ColorCoder V4 Service Manual page 125

3.4 Pick Up/Feeder System, cont'd.
3.4:A Roll Unit, cont'd.
Intermec ColorCoder V4 – Service Manual Ed. 1
Removing the Roll Drive Unit
Removing the Roll Drive Shaft
1. Untighten the screw (1) fixing the roll retainer and remove the
roll retainer (front) (2) from the roll drive shaft (3).
2. Untighten the screw (5) fixing the roll retainer (inner) (4) and
remove the roll retainer from the roll drive shaft.
3. Remove the spacer (6) from the roll drive shaft.
3
1
4. Remove four screws (2) fixing the roll motor cover (1) and
remove the cover.
2
1
Chapter 3
2
4
5
Figure 3-80
Figure 3-81
Mechanical System
6
2
124