Intermec ColorCoder V4 Service Manual page 231

6.6 Diagnosis, cont'd.
6.6:A Malfunction Indications,
cont'd.
Error No. Nature of Error
17 Cyan head abnormal tempera-
ture
18 Magenta head abnormal tem-
perature
19 Yellow head abnormal tempera-
ture
20 Environment abnormal tempera-
ture
21 Head position sensor abnormal-
ity
22 Cap position sensor abnormality
23 Serial communication error
24 Pressure cam home position sen-
sor abnormality
25 Waste ink full sensor abnormal-
ity
26 Ink overflow error
27 Low or no battery error of RTC
lithium battery
28 PHS lock abnormality
Intermec ColorCoder V4 – Service Manual Ed. 1
Probable Cause
Printing was carried out with no
discharge of ink. High duty print-
ing was carried out for a long
time, etc.
Printing was carried out with no
discharge of ink. High duty print-
ing was carried out for a long
time, etc.
Printing was carried out with no
discharge of ink. High duty print-
ing was carried out for a long
time, etc.
Ambient temperature or Engine
1 PCB abnormality.
Head position sensor out of or-
der, wiring connection abnor-
mality, head motor abnormality,
etc.
Cap position sensor out of order,
wiring connection abnormality,
cap motor abnormality, etc.
Engine 1 PCB or Formatter PCB
abnormality, defective connec-
tion.
Pressure cam home position sen-
sor out of order, wiring connec-
tion abnormality, pump motor
malfunction, etc.
Waste ink full sensor out of or-
der, wiring connection abnor-
mality, pump motor malfunc-
tion, etc.
Ink leak due to abnormality of
pump surroundings, broken sub
tank, malfunction of latch, bro-
ken or cracked tube, etc.
Low lithium battery, Engine 1
PCB or Formatter PCB abnor-
mality, defective connection.
PHS lock solenoid malfunction,
wiring connection abnormality,
etc.
Chapter 6 Troubleshooting
Corrective Action
Carry out Cleaning (B) and eliminate
non-discharge. Switch off power and
leave standing for a while.
Carry out Cleaning (B) and eliminate
non-discharge. Switch off power and
leave standing for a while.
Carry out Cleaning (B) and eliminate
non-discharge. Switch off power and
leave standing for a while.
Cool down ambient temperature, replace
Engine 1 PCB.
Replace head position sensor, check
wiring, replace head motor.
Replace Cap position sensor, check wir-
ing, replace cap motor.
Replace Engine 1 PCB or Formatter
PCB.
Replace pressure cam home position
sensor, check wiring, replace pump unit.
Replace waste ink full sensor, check
wiring, replace pump unit.
Replace pump unit, replace defective
place.
Replace Engine 1 PCB or Formatter
PCB.
Check wiring connection, replace sole-
noid.
230