Intermec ColorCoder V4 Service Manual page 241

6.7 Image Troubleshooting, cont'd.
6.7:A Measures to Take Against Faulty Images, cont'd.
Printing Position (Area) Slippage
Cause Step
Paper
Paper setting
Margin setting
Label gap setting
Nozzle position ad-
justment
TOF inlet sensor
Intermec ColorCoder V4 – Service Manual Ed. 1
Check Point
1 Is the special paper for this machine
being used?
2 Has the paper been properly loaded?
3 Have the paper settings been done cor-
rectly to the paper type and size being
used?
4 Have the margins been set to the appro-
priate values?
5 Has the gap between labels been cor-
rectly set to the gaps of the paper being
used?
6 Is the problem corrected when K nozzle
position adjustment and T-K distance
adjustment are carried out?
7 Is there any paper dust or dirt attached to
TOF inlet sensors 1 or 2?
8 Are TOF inlet sensors 1 or 2 working
properly?
Chapter 6 Troubleshooting
Result Corrective Action
No Use the special paper for the
machine.
No Load the paper properly.
No Set the paper type and size cor-
rectly with the paper set mode.
No Set the margins to appropriate
values with the margin set mode.
No Set the label gap to an appropri-
ate value with the label gap set
mode.
Yes Finished.
Yes Clean the TOF inlet sensors 1 or
2.
No Replace the TOF inlet sensors 1
or 2.
240