Intermec ColorCoder V4 Service Manual page 232

6.6 Diagnosis, cont'd.
6.6:A Malfunction Indications,
cont'd.
Error No. Nature of Error
29 Operating abnormality of latch
solenoid
30 Pressure clutch error
31 Suction clutch error
32 RTC power ON clear detection
44
Black head serial No. abnormal-
ity
45 Cyan head serial No. abnormal-
ity
46 Magenta head serial No. abnor-
mality
47 Yellow head serial No. abnor-
mality
48
Engine communication error
49
Cutter sensor abnormality (when
cutter is used)
60 Formatter system ROM abnor-
mality
61 Formatter system RAM abnor-
mality
Intermec ColorCoder V4 – Service Manual Ed. 1
Probable Cause
Malfunction of latch solenoid
position sensor, latch solenoid
out of order, wiring connection
abnormality, etc.
Failure of pressure clutch, wir-
ing connection error, etc.
Failure of suction clutch, wiring
connection error, etc.
Warning when battery is replaced
with the power switch turned
OFF, low lithium battery, no
battery, etc.
After replacing head or Engine 1
PCB, power switch was turn ON
as is, flexible cable connection
abnormality, etc.
After replacing head or Engine 1
PCB, power switch was turn ON
as is, flexible cable connection
abnormality, etc.
After replacing head or Engine 1
PCB, power switch was turn ON
as is, flexible cable connection
abnormality, etc.
After replacing head or Engine 1
PCB, power switch was turn ON
as is, flexible cable connection
abnormality, etc.
Communication abnormality
between Engine and Formatter.
Home position sensor, rotary
cutter blade, control PCB of cut-
ter unit or Formatter PCB
abnormality, etc.
Malfunction of system ROM in
Formatter PCB, wire breakage
of address bus or data bus, etc.
Malfunction of system RAM in
Formatter PCB, wire breakage
of address bus or data bus, etc.
Chapter 6 Troubleshooting
Corrective Action
Check wiring connection, replace sen-
sor, replace solenoid.
Check the wiring connection, replace
the pressure clutch, replace the engine 1
PCB.
Check the wiring connection, replace
the suction clutch, replace the engine 1
PCB.
After replacing Engine 1 PCB, turn on
power switch, and set the time.
Start up the power with service mode
(rewrite the head data of the Engine 1
PCB), check flexible cable connection.
Start up the power with service mode
(rewrite the head data of the Engine 1
PCB), check flexible cable connection.
Start up the power with service mode
(rewrite the head data of the Engine 1
PCB), check flexible cable connection.
Start up the power with service mode
(rewrite the head data of the Engine 1
PCB), check flexible cable connection.
Check wiring connection, replace En-
gine 1 PCB.
Check home position sensor, rotary cut-
ter blade, control PCB of cutter unit or
Formatter PCB.
Replace Formatter PCB.
Replace Formatter PCB.
231