Intermec ColorCoder V4 Service Manual page 220

6.5 Service Mode, cont'd.
6.5:D List of Service Mode, cont'd.
Control Panel Indication
V-NOZZLE ADJ.
T-K GAP ADJ.
K-C GAP ADJ.
C-M GAP ADJ.
M-Y GAP ADJ.
H-NOZZLE ADJ.
K NOZZLE ADJ.
C NOZZLE ADJ.
M NOZZLE ADJ.
Y NOZZLE ADJ.
STOP POS. ADJ.
CUTTER POS. ADJ.
Intermec ColorCoder V4 – Service Manual Ed. 1
Position Adjustment Mode
Description of Operation
Executes vertical registration adjustment of 4 colours, K, C, M, and Y.
Sets vertical direction position of black characters in the range of "T-K GAP="
-99 – +99 dots. Reference position of setting is the position of the TOF inlet
sensor.
Sets vertical direction position of cyan characters in the range of "K-C GAP="
-8 – +7 dots. Reference position of setting is the position of the black printing.
Sets vertical direction position of magenta characters in the range of "C-M
GAP=" -8 – +7 dots. Reference position of setting is the position of the cyan
printing.
Sets vertical direction position of yellow characters in the range of "M-Y
GAP=" -8 – +7 dots. Reference position of setting is the position of the
magenta printing.
Executes horizontal registration adjsutment of 4 colours, K, C, M, and Y. The
reference position of setting for all K, C, M, and Y is the left (rear) side of the
printable area of the paper.
Sets horizontal direction position of black characters in the range of "K
NOZZLE POS.=" -8 – +7 dots.
Sets horizontal direction position of cyan characters in the range of "C
NOZZLE POS.=" -8 – +7 dots.
Sets horizontal direction position of magenta characters in the range of "M
NOZZLE POS.=" -8 – +7 dots.
Sets horizontal direction position of yellow characters in the range of "Y
NOZZLE POS.=" -8 – +7 dots.
Sets paper stop position when printing operation completes or is discontinued
by the "PAUSE" key in the range of "STOP POS.=" -3.0 – +3.0 mm. This item
indicates when cutter unit is not connected.
Sets paper cut position by cutter unit in the range of "CUTTER POS.=" -2.0
~ +2.0 mm. This item is indicated when cutter unit is connected.
*
/. When C, M, or Y horizontal registration is adjusted, check for the head
shading effect and prepare new data, if necessary.
Chapter 6 Troubleshooting
219