NEC Univerge sv8500 Manual page 2151

[To Assign Gateway Address only]
MG(SIP) > set ipx_route
Route type(0: Exit/1: None/2: Static): 2
Select command (0: Exit/1: Set/2: Delete): 1
Select gateway type (0: Exit/1: Gateway/2: Default gateway): 2
Gateway IP address(0.0.0.0): 192.168.0.254
Route type: Static
Gateway address
--------------------------------------------------
192. 168. 0. 254 |
Are you sure? Y/N=y
MG(SIP) > _
Pressing any key other than "y" displays the following message.
Note 4:
Route setting command was interrupted.
Two or more Default Gateway cannot be registered.
Note:
To set a default gateway, it should be assigned to either LAN side port or SIP network side port.
Note:
| Destination network / Prefix
0. 0. 0. 0 / 0
VOL.2-1898
MG-SIP16 [SCA-16SIPMG(US)]
• When Static (=2) is selected
• Select 1 to set the data.
• Select Default gateway (=2) as a gate-
way type.
• Specify the default gateway IP
address (default: 0.0.0.0).
Note 4
• Enter "y" to set the data.